- Step 1 - Mount all wheels/tires with TPMS installed. - Step 2 - Install wheels/tires on vehicle and torque to specifications and place the vehicle on the ground. - Step 3 - Turn ignition to ON position. - Step 4 - Press the DIC RESET button to clear any warning messages. - Step 5 - Press the DIC OPTIONS button until the display goes blank. - Step 6 - Press and hold the DIC RESET button for 3 seconds. - Step 7 - Press the DIC OPTIONS button again until the "TIRE TRAINING" message appears. - Step 8 - Press the DIC RESET button until the message, "LEARN L FRONT TIRE" appears. - Step 9 - Hold the magnet over the pressure sensor's location on the LEFT FRONT wheel (this should be next to the valve stem if installed correctly). - Step 10 - When the horn beeps, programming is complete for that wheel. - Step 11 - Program the other 3 wheel sensors as directed by the message display. The sequence is as follows: Left Front, Right Front, Right Rear, Left Rear. - Step 12 - For more information, refer to the Corvette Service Manual, page 3-114:Low Tire Pressure Sensing-TPM Sensor Programming.